Added support for Telnet commands to generate BREAK

BREAK could be generated through Telnet command syntax (see RFC2217) by
offering "Set BREAK state ON", "Set BREAK state OFF" and "Request BREAK
state".
pull/249/head
Oliver 8 years ago
parent 5f425b2507
commit 1910386729
  1. 25
      serial/serbridge.c

@ -44,6 +44,9 @@ serbridgeConnData connData[MAX_CONN];
#define SetDataSize 2 // Set data size
#define SetParity 3 // Set parity
#define SetControl 5 // Set control lines
#define BRK_REQ 4 // request current BREAK state
#define BRK_ON 5 // set BREAK (TX-line to LOW)
#define BRK_OFF 6 // reset BREAK
#define DTR_ON 8 // used here to reset microcontroller
#define DTR_OFF 9
#define RTS_ON 11 // used here to signal ISP (in-system-programming) to uC
@ -156,6 +159,28 @@ telnetUnwrap(serbridgeConnData *conn, uint8_t *inBuf, int len)
}
if (in_mcu_flashing > 0) in_mcu_flashing--;
break;
case BRK_REQ:
char respBuf[7] = { IAC, SB, ComPortOpt, SetControl, GPIO_INPUT_GET(1), IAC, SE };
espbuffsend(conn, respBuf, 7);
#ifdef SERBR_DBG
os_printf("Telnet: BREAK state requested: state = %d)\n", GPIO_INPUT_GET(1));
#endif
break;
case BRK_ON:
while (((READ_PERI_REG(UART_STATUS(UART0))>>UART_TXFIFO_CNT_S)&UART_TXFIFO_CNT)>0); // wait until TX-FIFO of UART0 is empty
PIN_FUNC_SELECT(PERIPHS_IO_MUX_U0TXD_U, FUNC_GPIO1); // set TX pint to IO
GPIO_OUTPUT_SET(1, 0);
#ifdef SERBR_DBG
os_printf("Telnet: BREAK ON: set TX to LOW\n");
#endif
break;
case BRK_OFF:
GPIO_OUTPUT_SET(1, 1);
PIN_FUNC_SELECT(PERIPHS_IO_MUX_U0TXD_U, FUNC_U0TXD);
#ifdef SERBR_DBG
os_printf("Telnet: BREAK OFF: set TX to HIGH\n");
#endif
break;
}
state = TN_end;
break;

Loading…
Cancel
Save